Transfer Case Front Output Shaft Seal: Installation

WARNING: This page is about a different car, the 2013 Ford F-550 Super Duty, 2013 Ford F-450 Super Duty, 2013 Ford F-350 Super Duty, and 2013 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.

Using the Output Shaft Oil Seal Installer with the Handle, install a new front output seal.

Fig 1: Installing Front Output Seal
Courtesy of FORD MOTOR CO.
Using the Drive Pinion Flange Holding Fixture to prevent the flange from turning, install the front flange and a new front driveshaft flange nut.
- Tighten to 223 Nm (164 lb-ft).
  
  Fig 2: Installing Front Flange And Front Driveshaft Flange Nut
  Courtesy of FORD MOTOR CO.
NOTE: Align the index marks made during removal.

Install the front driveshaft. For additional information, refer to DRIVESHAFT .
If equipped, install the skid plate and the 4 bolts.
- Tighten to 24 Nm (18 lb-ft).