LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Explorer Base, 3.5 8, AWD, 6F50 >> Repair and Diagnosis >> External Pages >> Different car >> Section 102 (Anti-Theft System - Passive Anti-Theft System) >> Removal And Installation >> Passive Anti-Theft System (PATS) Transceiver >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2013 Ford F-550 Super Duty, 2013 Ford F-450 Super Duty, 2013 Ford F-350 Super Duty, and 2013 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the lower steering column shroud. For additional information, refer to STEERING COLUMN .
  2. Disconnect the Passive Anti-Theft System (PATS) transceiver electrical connector.
  3. Using a suitable tool (such as a dentist pick), unclip the 2 tabs and remove the PATS transceiver.
  4. NOTE: Replacement of the PATS transceiver does not require the Integrated Keyhead Transmitters (IKTs) keys to be programmed into the Body Control Module (BCM).

    To install, reverse the removal procedure.

scientia non olet · About LEMON Manuals