LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Explorer Base, 3.5 8, AWD, 6F50 >> Repair and Diagnosis >> External Pages >> Different car >> Section 101 (Fuel Charging System & Fuel Control System - 6.2L) >> Removal And Installation >> Throttle Body >> Installation

Throttle Body: Installation

WARNING: This page is about a different car, the 2013 Ford F-350 Super Duty and 2013 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
  1. Using a new O-ring seal, position the TB and tighten the 4 bolts in 2 stages.
    • Stage 1: Tighten to 12 Nm (106 lb-in).
    • Stage 2: Tighten an additional 60 degrees.
  2. Connect the ETC electrical connector.
  3. Position the TB adapter onto the TB and install the 2 bolts.
    • Tighten to 10 Nm (89 lb-in).
  4. Tighten the TB adapter-to-TB clamp.
    • Tighten to 5 Nm (44 lb-in).
  5. Connect the crankcase ventilation tube quick connect coupling to the ACL outlet pipe-to-TB adapter. For additional information, refer to FUEL SYSTEM - GENERAL INFORMATION - GASOLINE AND DIESEL .
  6. Connect the brake booster vacuum hose to the ACL outlet pipe-to-TB adapter.
  7. Connect the crankcase ventilation tube quick connect fitting to the ACL outlet pipe-to-TB adapter. For additional information, refer to FUEL SYSTEM - GENERAL INFORMATION - GASOLINE AND DIESEL .
  8. Connect the heater coolant hose retainer to the ACL outlet pipe-to-TB adapter.
  9. Install the ACL outlet tube. For additional information, refer to INTAKE AIR DISTRIBUTION & FILTERING .
scientia non olet · About LEMON Manuals