LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Explorer Base, 3.5 8, AWD, 6F50 >> Repair and Diagnosis >> External Pages >> Different car >> Section 100 (Automatic Transmission Cooling System) >> Removal And Installation >> Transmission Fluid Cooler Tubes - 6.2L >> Installation

Transmission Fluid Cooler Tubes - 6.2L: Installation

WARNING: This page is about a different car, the 2013 Ford F-550 Super Duty, 2013 Ford F-450 Super Duty, 2013 Ford F-350 Super Duty, and 2013 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the rear transmission fluid cooler tube assembly in the vehicle and connect the rear transmission fluid cooler tubes to the transmission case.
    • Tighten to 40 Nm (30 lb-ft).
      Fig 1: Locating Transmission Case Mounting Bolt
      G07482974Courtesy of FORD MOTOR CO.
  2. Position the transmission fluid cooler tube assembly and starter motor wiring harness brackets on the stud and install the nut.
    • Tighten to 25 Nm (18 lb-ft).
      Fig 2: Locating Transmission Cooler Lines, Starter Motor Wiring Harness Brackets And Nut
      G07968911Courtesy of FORD MOTOR CO.
  3. Connect the battery. For additional information, refer to BATTERY, MOUNTING AND CABLES .
  4. Install the front transmission fluid cooler tube assembly in the vehicle and attach the pin-type retainer to the frame rail.
    Fig 3: Locating Pin-Type Retainer
    G07483455Courtesy of FORD MOTOR CO.
  5. Connect the transmission fluid cooler tube assemblies.
    Fig 4: Locating Transmission Fluid Cooler Tube Assembly
    G07483469Courtesy of FORD MOTOR CO.
  6. Install the front transmission fluid cooler tube secondary latches.
    Fig 5: Locating Front Transmission Fluid Cooler Tube Secondary Latches
    G07483453Courtesy of FORD MOTOR CO.
  7. Connect the front transmission fluid cooler tube to the OTA fluid cooler.
    Fig 6: Locating OTA Fluid Cooler Transmission Fluid Cooler Tube
    G07483423Courtesy of FORD MOTOR CO.
  8. Install the lower air deflector and 3 pushpins.
    Fig 7: Locating Lower Air Deflector Pushpins
    G07483422Courtesy of FORD MOTOR CO.
  9. Install the 3 remaining pushpins in the lower air deflector.
    Fig 8: Locating Lower Air Deflector Pushpins
    G07483421Courtesy of FORD MOTOR CO.
  10. Connect the front transmission fluid cooler tube to the radiator in-tank cooler.
    Fig 9: Locating Front Transmission Front Fluid Cooler Tube At Radiator In-Tank Cooler
    G07483449Courtesy of FORD MOTOR CO.
  11. Position back the A/C condenser and install the 2 bolts.
    • Tighten to 8 Nm (71 lb-in).
      Fig 10: Locating A/C Condenser Bracket Bolts
      G06778479Courtesy of FORD MOTOR CO.
  12. Install the radiator grille. For additional information, refer to EXTERIOR TRIM AND ORNAMENTATION .
  13. Fill with transmission fluid and check for leaks.
scientia non olet · About LEMON Manuals