DTC P0403: Exhaust Gas RECIRCULATION (EGR) Control Circuit

P0403 - EXHAUST GAS RECIRCULATION (EGR) CONTROL CIRCUIT

For Vehicles With an Electric EGR (EEGR)
Description: The electric EGR (EEGR) system is continuously monitored to check the four EEGR motor coils, circuits, and the PCM for opens, shorts to voltage and ground. If a concern is detected, the EEGR system is disabled and additional monitoring is suspended for the remainder of the drive until the next drive cycle.
Possible Causes: EEGR motor windings open EEGR connector not seated correctly EEGR circuit from the PCM harness open EEGR motor circuit short EEGR circuit from the PCM harness short PCM
Diagnostic Aids:
For All Others
Description: This test checks the electrical function of the EGR vacuum regulator solenoid. The test fails when the EVR circuit voltage is either too high or too low when compared to the expected voltage range. The EGR system must be enabled for the test to be completed.
Possible Causes: EVR circuit open EVR circuit short to voltage or ground VPWR open to EGR vacuum regulator solenoid EGR vacuum regulator solenoid PCM
Diagnostic Aids: The EGR vacuum regulator solenoid resistance is between 26 and 40 ohms.
Application	Key On Engine Off	Key On Engine Running	Continuous Memory
E-Series 4.6L, Mustang 5.4L	GO to PINPOINT TEST HH .
Escape, Fusion 2.5L, Fusion 3.0L, Transit Connect	GO to PINPOINT TEST KD .