DTC P0400: Exhaust Gas RECIRCULATION (EGR) Flow

P0400 - EXHAUST GAS RECIRCULATION (EGR) FLOW

Description: The electric EGR (EEGR) system is monitored once per drive cycle at high and low load conditions. The test fails when a concern is detected by PCM calculations indicating the EGR flow is less or greater than expected.
Possible Causes: EEGR valve stuck open or closed EEGR connector not seated correctly EEGR motor windings short or open No voltage to the EEGR Harness open or short to voltage or ground Vacuum signal to manifold absolute pressure (MAP) sensor restricted or leaking Mass airflow (MAF) sensor signal erroneous Carbon build up in the EEGR valve seat area One or more sensors is not responding or is out of range
Diagnostic Aids: The following sensors input data to the PCM for correct operation of the EEGR system: engine coolant temperature (ECT), crankshaft position (CKP), intake air temperature (IAT), MAF, throttle position (TP), MAP and vehicle speed sensor (VSS). Diagnose any DTC relating to these sensors prior to addressing this DTC.
Application	Key On Engine Off	Key On Engine Running	Continuous Memory
All	GO to PINPOINT TEST KD .