LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Explorer Base, 3.5 8, AWD, 6F50 >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Engine System - General Information >> Component Test(S) >> Valve Seat Width >> General Procedure

General Procedure

NOTE: For specifications refer to the appropriate engine mechanical article. For 2.0L GTDI, refer to the GENERAL SPECIFICATIONS , or for 3.5L Ti-VCT, refer to the GENERAL SPECIFICATIONS tables.
  1. Measure the valve seat width. If necessary, grind the valve seat to specification.
    • Measure the intake valve seat width.
    • Measure the exhaust valve seat width.
    • Recheck the valve spring installed length after the seats have been ground, and shim the valve springs as necessary to achieve the correct installed spring length.
    Fig 1: Measuring Valve Seat Width
    G06289048Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals