General Procedure

NOTE: For specifications refer to the appropriate engine mechanical article. For 2.0L GTDI, refer to the GENERAL SPECIFICATIONS , or for 3.5L Ti-VCT, refer to the GENERAL SPECIFICATIONS tables.

NOTE: After grinding valves or valve seats, always check valve clearance.

Check the valve head and seat.
- Check valve angles.
- Check margin width.
- Be sure margin width is within specification.
Fig 1: Identifying Valve Angles And Margin Width
Courtesy of FORD MOTOR CO.
Inspect for abnormalities on the valve face and seat. Install a new cylinder head assembly if abnormalities are found.