LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Explorer Base, 3.5 8, AWD, 6F50 >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Engine System - General Information >> Component Test(S) >> Crankshaft End Play >> General Procedure

General Procedure

NOTE: For specifications refer to the appropriate engine mechanical article. For 2.0L GTDI, refer to the GENERAL SPECIFICATIONS , or for 3.5L Ti-VCT, refer to the GENERAL SPECIFICATIONS tables.
  1. Install the Dial Indicator Gauge with Holding Fixture.
  2. Position the crankshaft to the rear of the cylinder block.
  3. Zero the Dial Indicator Gauge.
  4. Move the crankshaft to the front of the cylinder block. Note and record the crankshaft end play.
    Fig 1: Checking Crankshaft End Play Using Dial Indicator Gauge
    G06064065Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals