LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Explorer Base, 3.5 8, AWD, 6F50 >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Engine System - General Information >> Component Test(S) >> Camshaft End Play >> General Procedure

General Procedure

NOTE: For specifications refer to the appropriate engine mechanical article. For 2.0L GTDI, refer to the GENERAL SPECIFICATIONS , or for 3.5L Ti-VCT, refer to the GENERAL SPECIFICATIONS tables.
  1. Using the Dial Indicator Gauge with Holding Fixture, measure the camshaft end play.
  2. Position the camshaft to the rear of the cylinder head.
  3. Zero the Dial Indicator Gauge.
  4. Move the camshaft to the front of the cylinder head. Note and record the camshaft end play.
    • If camshaft end play exceeds specifications, install a new camshaft and recheck end play.
    • If camshaft end play exceeds specification after camshaft installation, install a new cylinder head.
    Fig 1: Checking Camshaft End Play
    G06064054Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals