LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Explorer Base, 3.5 8, AWD, 6F50 >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Engine Mechanical - 3.5L-Ti-VCT >> Removal And Installation >> Engine Oil Pressure (EOP) Switch >> Installation

Engine Oil Pressure (EOP) Switch: Installation

  1. NOTE: Apply Thread Sealant with PTFE to the EOP switch threads prior to installation.

    Install the EOP switch.

    • Tighten to 14 Nm (124 lb-in) plus an additional 180 degrees.
    Fig 1: Identifying EOP Switch
    G08029513Courtesy of FORD MOTOR CO.
  2. Connect the EOP switch electrical connector.
    Fig 2: Locating EOP Switch Electrical Connector
    G08029512Courtesy of FORD MOTOR CO.
  3. If equipped, install the engine oil cooler. REFER to Oil Cooler .
scientia non olet · About LEMON Manuals