Engine Mount: Installation

Position the engine mount onto the engine studs and install the 4 nuts and 3 bolts hand tight.
- Tighten the 3 engine mount-to-frame bolts to 90 Nm (66 lb-ft).
- Tighten the 4 engine mount-to-engine nuts to 63 Nm (46 lb-ft).
Fig 1: Locating Engine Mounting Nuts And Bolts
Courtesy of FORD MOTOR CO.
Install the 3 twist-type retainers and the air duct to the subframe.

Fig 2: Locating Underbody Air Duct And Twist Lock Retainers
Courtesy of FORD MOTOR CO.
Install degas bottle. REFER to DEGAS BOTTLE .