Crankshaft Pulley: Installation

Lubricate the crankshaft front seal inner lip with clean engine oil.
NOTE: Lubricate the outside diameter sealing surfaces with clean engine oil.

Using 303-102 (T74P-6316-B) and 303-335 (T88T-6701-A), install the crankshaft pulley.

Fig 1: Installing Crankshaft Pulley Using Tools
Courtesy of FORD MOTOR CO.
Using 303-D055 (D85L-6000-A), install the crankshaft pulley washer and new bolt and tighten in 4 stages.
- Stage 1: Tighten to 120 Nm (89 lb-ft).
- Stage 2: Loosen one full turn.
- Stage 3: Tighten to 50 Nm (37 lb-ft).
- Stage 4: Tighten an additional 90 degrees.
Fig 2: Installing Crankshaft Pulley Washer And New Bolt
Courtesy of FORD MOTOR CO.
Install the accessory drive belt. REFER to ACCESSORY DRIVE .
Install the RH splash shield. REFER to FENDER SPLASH SHIELD .