LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Explorer Base, 3.5 8, AWD, 6F50 >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Engine Mechanical - 3.5L-Ti-VCT >> Disassembly And Assembly Of Subassemblies >> Cylinder Head >> Assembly

Cylinder Head: Assembly

  1. Install the valve.
    Fig 1: Identifying Cylinder Head Valve
    G08030183Courtesy of FORD MOTOR CO.
  2. NOTE: Lubricate the valve stem seal with clean engine oil prior to installation.

    Using The 303-470  (T94P-6510-CH), install a new valve stem seal.

    Fig 2: Installing Valve Stem Seal
    G08030188Courtesy of FORD MOTOR CO.
  3. Using The 303-300  (T87C-6565-A), 303-350  (T89P-6565-A) and 303-1249  , install the valve spring, retainer and key.
    • Repeat the above steps for each valve.
    Fig 3: Removing/Installing Keys, Retainer And Valve Spring
    G08030181Courtesy of FORD MOTOR CO.
  4. Install the timing chain guide pin.
    • Tighten to 10 Nm (89 lb-in).
    Fig 4: Location Of Timing Chain Guide Pin
    G08030184Courtesy of FORD MOTOR CO.
  5. Install the timing chain tensioner arm pin on the RH cylinder head.
    • Tighten to 10 Nm (89 lb-in).
    Fig 5: Location Of Timing Chain Tensioner Arm Pin - RH Cylinder Head
    G08030185Courtesy of FORD MOTOR CO.
  6. Install a new CHT sensor in the RH cylinder head.
    • Tighten to 10 Nm (89 lb-in).
    Fig 6: Locating CHT Sensor In RH Cylinder Head
    G08030186Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals