LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Explorer Base, 3.5 8, AWD, 6F50 >> Repair and Diagnosis >> Engine Mechanical >> Exhaust >> Exhaust System >> Removal And Installation >> Exhaust Y-Pipe >> Removal

Exhaust Y-Pipe: Removal

NOTE: Do not excessively bend, twist or allow the exhaust to hang from the flexible pipe or damage to the exhaust system may occur.
NOTE: Do not use oil or grease-based lubricants on the isolators. These lubricants may cause deterioration of the rubber. This can lead to separation of the isolator from the exhaust hanger bracket during vehicle operation. Use only water-based lubricants on the isolators.
NOTE: Always install new nuts and gaskets. Clean flange faces prior to new gasket installation to make sure of correct sealing.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, REFER to JACKING AND LIFTING for lifting points.
  2. Support the muffler and tailpipe with a suitable jackstand.
  3. Loosen the Torca® clamp retainer.
  4. NOTE: Do not damage or tear the isolators during removal.

    Using soapy water, detach the exhaust Y-pipe isolator.

  5. Remove and discard the 4 exhaust Y-pipe-to-LH and RH catalytic converter nuts and remove the exhaust Y-pipe.
    • Discard the gasket.
scientia non olet · About LEMON Manuals