Exhaust Flexible Pipe: Removal

With the vehicle in NEUTRAL, position it on a hoist. REFER to JACKING AND LIFTING for lifting points.
Loosen the Torca® clamp retainer.
- Tighten to 55 Nm (41 lb-ft).
Fig 1: View Of Torca Clamp Retainer Fastener
Courtesy of FORD MOTOR CO.
NOTE: Do not damage or tear the isolator during removal.

Using soapy water, detach the exhaust flexible pipe isolator.

Fig 2: View Of Exhaust Flexible Pipe Isolator
Courtesy of FORD MOTOR CO.
NOTE: Install a new gasket and 2 new nuts.

Remove the flexible pipe and discard the 2 nuts and gasket.
- Tighten to 40 Nm (30 lb-ft).
Fig 3: Removing Flexible Pipe Nuts
Courtesy of FORD MOTOR CO.