Catalytic Converter - RH, AWD: Installation

NOTE: Do not excessively bend, twist or allow the exhaust to hang from the flexible pipe or damage to the exhaust system may occur.

NOTE: Exhaust fasteners are of a torque prevailing design. Use only new fasteners with the same part number as the original. Torque values must be used as specified during reassembly to make sure of correct retention of exhaust components.

NOTE: Make sure to tighten the 4 new nuts in the following sequence.

Install a new RH catalytic converter gasket, position the RH catalytic converter and tighten the 4 new nuts in the sequence shown illustration.
- Tighten to 40 Nm (30 lb-ft).
Fig 1: Identifying Tightening Sequence Of RH Catalytic Converter Mounting Nuts
Courtesy of FORD MOTOR CO.
Install the Transmission Support Insulator - Anti Roll AWD. REFER to TRANSMISSION SUPPORT INSULATOR -- ANTI-ROLL AWD
Install the exhaust Y-pipe. REFER to Exhaust Y-Pipe .
Install the RH CMS. REFER to CATALYST MONITOR SENSOR - 3.5L TI-VCT .
Install the splash shield and attach the 3 retainers.

Fig 2: Locating Splash Shield Retainers
Courtesy of FORD MOTOR CO.