Drive Pinion Seal: Installation

NOTE: Make sure the mating surface is clean before installing the new pinion seal.

Using the Pinion Seal Replacer 205-133 (T79P-4676-A), install the new pinion seal.

Fig 1: Installing Pinion Seal Using Pinion Seal Replacer
Courtesy of FORD MOTOR CO.
NOTE: Lubricate the pinion flange with grease.

Align the index marks and position the pinion flange to the pinion.

Fig 2: Identifying Index-Mark Of Pinion
Courtesy of FORD MOTOR CO.
Using the Drive Pinion Flange Holding Fixture 205-126 (T78P-4851-A), install the new pinion nut.
- Tighten to 244 Nm (180 lb-ft).
Fig 3: Holding Pinion Flange Using Drive Pinion Flange Holding Fixture
Courtesy of FORD MOTOR CO.
Install the driveshaft. REFER to DRIVESHAFT .