Window Glass - Rear: Removal

Remove rear wiper motor. REFER to WIPER MOTOR - REAR WINDOW .
Remove the liftgate spoiler. REFER to SPOILER .
Disconnect the 2 liftgate window defrost electrical connectors.
WARNING: Always wear eye protection when servicing a vehicle. Failure to follow this instruction may result in serious personal injury.
Wear protective gloves when handling components or parts that have pointed or sharp edges. Failure to follow this instruction may result in serious personal injury.

NOTE: To avoid rust formation, use extreme care not to scratch the paint or primer, or otherwise damage the pinch weld during glass removal.

NOTE: Lubricate the existing urethane adhesive with water to aid the 300-AST1770E while cutting.

NOTE: Insert the blade into the 300-AST1770E so that the flat side is against the glass. This will leave the entire urethane adhesive bead on the pinch weld and allow a dry fit of the replacement rear glass.

Using the 300-AST1770E , begin cutting the urethane adhesive at the top center and work toward the bottom corners.
Using the 300-AST1770E , cut the remaining urethane adhesive and remove the rear window glass.