Seat Cushion Cover - Manual: Installation
- Position the cushion cover to the cushion foam pad and attach the retainers.
- Secure the cushion trim cover retainers to the cushion frame.
- Install the floor latch cover and screw.
- Install the load floor panel.
- Install the 2 screws on each side at the bottom of the load floor panel.
- Install the pivot release handle and attach the pivot release cable and casing.
- Install the cushion handle and the 2 screw(s).
NOTE:
The lower anchors and tethers for children and child safety seat tether anchor must be accessible through the trim cover.