Seat Backrest - Manual: Removal
NOTE:
For component identification and locations, REFER to Seat - Exploded View .
NOTE:
To remove the RH third row seat backrest, the LH seat outboard pivot cover must be removed before the RH seat outboard pivot cover can be removed.
- Pry to release the clips and remove the LH seat outboard pivot cover.
- Pry to release the clips and remove the RH seat outboard pivot cover.
- Release the backrest trim cover lower J-strip, open the trim cover and release the inner J-clips.
- Remove the pivot bolt.
- To install, tighten to 54 Nm (40 lb-ft).
- Roll the backrest trim cover up, remove the 2 backrest latch-to-backrest frame bolts and remove the backrest frame.
- To install, tighten to 83 Nm (61 lb-ft).
NOTE:
LH or RH backrest
NOTE:
RH backrest
NOTE:
LH or RH backrest