LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Explorer Base, 3.5 8, AWD, 6F50 >> Repair and Diagnosis >> Body & Frame >> Seats >> Seat System - Seats-Seating - 1ST Row >> Removal And Installation >> Dual Climate Controlled Seat Module (DCSM) >> Installation

Dual Climate Controlled Seat Module (DCSM): Installation

  1. Install the DCSM in the following sequence.
    • Connect the electrical connectors.
    • Secure the locking wedges on the 2 DCSM electrical connectors.
    • Position the DCSM and install the screws.
  2. NOTE: This step is necessary only if the DCSM is being replaced.

    PMI is required when installing a new DCSM. Refer to the scan tool instructions to carry out PMI. REFER to PROGRAMMABLE MODULE INSTALLATION (PMI) .

scientia non olet · About LEMON Manuals