LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Explorer Base, 3.5 8, AWD, 6F50 >> Repair and Diagnosis >> Body & Frame >> Door Locks >> Handles, Locks, Latches And Entry Systems - Without Intelligent Access >> Pinpoint Tests >> Diagnostic Routine O >> Pinpoint Test

Pinpoint Test

  1. CHECK THE LATCH OPERATION FROM BOTH DOOR HANDLES
    1. Open the door using both the interior and exterior door handles.

    Does the door open normally from one of the door handles? 

  2. CHECK THE LATCH OPERATION
    1. Open the door.
    2. Using a screwdriver, fully close the latch (2 clicks).
      Fig 1: Closing Latch Using Screwdriver
      G06071166Courtesy of FORD MOTOR CO.
    3. Verify the latch releases easily while pulling on the interior/exterior door handle.

    Does the latch release easily? 

    • Yes: GO to  4.
    • No: GO to .
  3. CHECK THE LATCH OPERATION AFTER LUBRICATION
    1. Lubricate the door latch. REFER to Latch Lubrication .
    2. Using a screwdriver, fully close the latch (2 clicks).
      Fig 2: Closing Latch Using Screwdriver
      G06071166Courtesy of FORD MOTOR CO.
    3. Verify the latch releases easily while pulling on the interior/exterior door handle.

    Does the latch release easily? 

  4. CHECK THE STRIKER ADJUSTMENT
    1. Check the adjustment of the striker.

    Is the striker adjusted correctly? 

    • Yes: GO to .
    • No: ADJUST the striker as necessary.
  5. CHECK THE DOOR ALIGNMENT
    1. Check the alignment of the door. REFER to DOOR ALIGNMENT - FRONT , or REFER to DOOR ALIGNMENT - REAR .

    Is the door aligned correctly? 

    • Yes: LUBRICATE the door hinges.
    • No: ADJUST the door as necessary.