LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Explorer Base, 3.5 8, AWD, 6F50 >> Repair and Diagnosis >> Body & Frame >> Door Locks >> Handles, Locks, Latches And Entry Systems - Without Intelligent Access >> General Procedures >> Latch Lubrication >> General Procedure

General Procedure

  1. Open the door.
  2. Using a flat-blade screwdriver, fully close the latch (2 clicks).
    Fig 1: Closing Latch Using Screwdriver
    G06071166Courtesy of FORD MOTOR CO.
  3. NOTE: Do not over lubricate the latch. Using excessive grease may damage the internal lock motor.

    Spray the multi-purpose grease into the opening on the door latch for approximately 5 seconds.

    Fig 2: Spraying Multi-Purpose Grease Into Door Latch Opening
    G06077610Courtesy of FORD MOTOR CO.
  4. Open the latch using either the interior or exterior door handle.
  5. Open and close the door several times to circulate the lubricant inside the latch.
  6. Wipe off any excess grease.
scientia non olet · About LEMON Manuals