Integrated Keyhead Transmitter (IKT)

NOTE: The IKTs must have SA stamped on the keyblade. Conventional PATS keys must have HA or SA stamped on the keyblade.

Fig 1: Identifying Integrated Keyhead Transmitter (IKT)

Courtesy of FORD MOTOR CO.

The IKT incorporates both the PATS functions and the RKE transmitter functions in a single device.

During key programming procedures, the PATS and RKE transmitter of an IKT are both programmed into the BCM. REFER to KEY PROGRAMMING USING DIAGNOSTIC EQUIPMENT , or REFER to KEY PROGRAMMING USING TWO PROGRAMMED KEYS to program the IKTs . Conventional PATS keys can also be programmed to the vehicle if requested by the customer.

Up to a maximum of 4 IKTs can be programmed. If more than 4 IKTs are programmed, INT KEY COULD NOT PROGRAM is displayed in the message center during the key programming procedure and the RKE function of that IKT is non-functional.