LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Explorer Base, 3.5 8, AWD, 6F50 >> Repair and Diagnosis >> Accessories & Equipment >> Wiper/Washer Systems >> Wiper System & Washer System >> General Procedures >> Washer Hose Repair >> General Procedure

General Procedure

  1. Locate and verify the leaking washer hose.
  2. Cut the hose cleanly and remove the damaged portion of the washer hose.
    Fig 1: Identifying Washer Hose Cutting Dimension
    G06099936Courtesy of FORD MOTOR CO.
  3. Install a windshield washer hose adapter between the cut ends of the hose.
  4. NOTE: In difficult cases, clamping may be required.

    Install a segment of 6.4 mm (0.252 in) inside diameter black rubber hose over the ends of the washer hose, and clamp both ends of the rubber hose using spring clamps.

scientia non olet · About LEMON Manuals