Steering Column Control Module (SCCM): Removal

Remove the clockspring. REFER to CLOCKSPRING .
Disconnect the 3 SCCM electrical connectors.

Fig 1: Locating Steering Column Control Module Electrical Connectors
Courtesy of FORD MOTOR CO.
Remove the 2 SCCM screws.
- To install, tighten to 3 Nm (27 lb-in).
Fig 2: Locating Steering Column Control Module Mounting Screws
Courtesy of FORD MOTOR CO.
Push the SCCM locking tab upward and remove the SCCM.

Fig 3: Pushing Steering Column Control Module Locking Tab Upward
Courtesy of FORD MOTOR CO.