Pinpoint Test

1. Ignition ON.
2. Verify there is an observable symptom present.

Is an observable symptom present? 

1. Yes: GO to 2  .
2. No: The system is operating normally at this time. The DTC may have been set due to high network traffic or an intermittent fault condition.

1. Ignition ON.
2. Using a scan tool, perform a network test.
3. Carry out the network test.

Does the RCM pass the network test? 

1. Yes: GO to 3  .
2. No: REFER to DIAGNOSTIC ROUTINE C : The Restraints Control Module (RCM) Does Not Respond To The Scan Tool.

1. Using a scan tool, perform the RCM self-test.

Is DTC U3003:16 or DTC U3003:17 recorded? 

1. Yes: REFER to DIAGNOSTIC ROUTINE Y : U3003:16 and U3003:17.
2. No: GO to 4  .

1. Using a scan tool, perform the IPC self-test.

Is DTC U3003:16 or DTC U3003:17 recorded? 

1. Yes: For DTC U3003:16, REFER to Diagnostic Routine BD: U3003:16 .

   For DTC U3003:17, REFER to Diagnostic Routine BE: U3003:17 .

2. No: GO to 5  .

1. Clear the DTCs  .
2. Wait 10 seconds.
3. Repeat the IPC self-test.

Is DTC U0151:00 still present? 

1. Yes: GO to 6  .
2. No: The system is operating correctly at this time. The DTC may have been set due to high network traffic or an intermittent fault condition.

1. Clear all DTCs  .
2. Ignition OFF.
3. Ignition ON.
4. Wait 10 seconds.
5. Using a scan tool, perform self-test.
6. Retrieve the continuous memory DTCs  from all modules.

Is DTC U0151:00 set in the OCSM? 

1. Yes: INSTALL a new RCM. REFER to RESTRAINTS CONTROL MODULE (RCM) .
2. No: INSTALL a new IPC. REFER to Instrument Panel Cluster (IPC) .