Pinpoint Test

1. Operate the cruise control.

Does the cruise control operate correctly? 

1. Yes: GO to 2  .
2. No: For standard cruise control, REFER to SYMPTOM CHART: CRUISE CONTROL .

   For adaptive cruise control, REFER to SYMPTOM CHART: CRUISE CONTROL .

1. Close all doors, hood and liftgate.
2. Ignition ON.
3. NOTE: If multiple warnings are present, the message center cycles through each of the warning indicators. Allow the message center to cycle through each display while determining whether the door ajar message center warning indicator is active.

   Open the driver door while monitoring the door ajar message center warning indicator.

Does the driver door ajar message center warning indicator turn off with the driver door closed and illuminate with the driver door open? 

1. Yes: GO to 3  .
2. No: INSTALL a new IPC. REFER to Instrument Panel Cluster (IPC) .

1. Using a scan tool, perform the PCM KOEO self-test.

Are any PCM DTCs recorded? 

1. Yes: REFER to SECTION 3: SYMPTOM CHARTS .
2. No: GO to 4  .

1. Using a scan tool, perform the IPC self-test.

Are any DTCs recorded? 

1. Yes: For IPC DTC U0100:00, REFER to Diagnostic Routine AR: U0100:00 .

   For all other DTCs  , REFER to DTC Chart: Instrument Panel Cluster (IPC) .

2. No: INSTALL a new PCM. REFER to POWERTRAIN CONTROL MODULE (PCM) - 2.0L GTDI , or REFER to POWERTRAIN CONTROL MODULE (PCM) - 3.5L TI-VCT .