Removal And Installation

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

Depower the supplemental restraint system (SRS). For additional information, refer to SUPPLEMENTAL RESTRAINT SYSTEM article.
Insert the ignition key into the lock cylinder and turn the ignition switch to the RUN position.
- Push the ignition switch lock cylinder release tab with a punch while pulling out the ignition switch lock cylinder.
Fig 1: Pushing Ignition Lock Cylinder Release Tab While Pulling Ignition Lock Cylinder Out Of Steering Column
Courtesy of FORD MOTOR CO.
If equipped, twist the tilt wheel handle and remove it.
Remove the 3 screws and the upper and lower steering column shrouds.
Remove the key release button.
- Remove the bolt.
- Remove the spring.
- Remove the key release button.
Fig 2: Identifying Key Release Button, Spring And Bolt
Courtesy of FORD MOTOR CO.
To install, reverse the removal procedure.
Repower the supplemental restraint system (SRS). For additional information, refer to SUPPLEMENTAL RESTRAINT SYSTEM article.