Brake Caliper Anchor Plate

Brake Caliper Anchor Plate

Removal and Installation

1. Remove the wheel and tire.

2. NOTICE: Do not allow the caliper to hang from the brake hose or damage to the hose can occur.

Remove the 2 brake caliper guide pin bolts and position the caliper aside.
- Support the caliper using mechanic's wire.


3. Remove the 2 brake caliper anchor plate bolts.
- To install, tighten to 175 Nm (129 lb-ft).


4. Remove the brake caliper anchor plate.

5. To install, reverse the removal procedure.