Accessory Drive Belt Tensioner

Accessory Drive Belt Tensioner

Removal and Installation

1. With the vehicle in NEUTRAL, position it on a hoist.

2. NOTE: The accessory drive belt tensioner must be replaced as a complete unit.
Remove the pin-type retainer, 5 bolts and the RH splash shield.

- To install, tighten to 9 Nm (80 lb-in).


3. Using the hex feature, rotate the accessory drive belt tensioner clockwise and remove the accessory drive belt from the coolant pump pulley.





4. NOTE: The accessory drive belt tensioner must be replaced as a complete unit.
Remove the 2 bolts and the accessory drive belt tensioner.

- To install, tighten to 25 Nm (18 lb-ft).


5. To install, reverse the removal procedure.