Wiper Motor - Rear Window

Wiper Motor - Rear Window

Removal and Installation

1. Remove the rear wiper pivot arm. For additional information, refer to Wiper Pivot Arm - Rear Wiper Pivot Arm - Rear.

2. Remove the 3 nuts and the wiper motor cover.

3. Disconnect the washer fluid hose and electrical connector from the wiper motor.

4. Remove the 3 nuts and the wiper motor.
- To install, tighten to 8 Nm (71 lb-in).

5. To install, reverse the removal procedure.
- Verify the window grommet is properly seated before installing the wiper motor.