LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2011 >> Taurus SEL, FWD >> Repair and Diagnosis (Single Page) >> Electrical >> Gauges >> Information Center - Instrumentation, Message Center, And Warning Chimes >> Diagnosis And Testing >> Instrumentation, Message Center and Warning Chimes >> Pinpoint Tests >> Pinpoint Test BB: DTC U0208:00 >> Pinpoint Test BB: DTC U0208:00

Pinpoint Test BB: DTC U0208:00

  1. BB1 VERIFY THE CUSTOMER CONCERN 
    • Ignition ON.
    • Verify that there is an observable symptom present.
    • Is an observable symptom present? 
    • Yes  : GO to BB2.
    • No  : The system is operating normally at this time. The DTC may have been set due to high network traffic or an intermittent fault condition.
  2. BB2 CHECK THE COMMUNICATION NETWORK 
    • Ignition ON.
    • Enter the following diagnostic mode on the scan tool: Network Test.
    • Carry out the network test.
    • Does the DSM pass the network test? 
  3. BB3 RETRIEVE THE RECORDED DTCs FROM THE IPC SELF-TEST 
    • Check for recorded DTCs from the IPC self-test.
    • Is DTC U3003:16 or DTC U3003:17 recorded? 
  4. BB4 RECHECK THE IPC DTCs 
    NOTE: If new modules were installed prior to the DTC being set, the module configuration may be incorrectly set during the Programmable Module Installation (PMI) or the PMI may not have been carried out.
    • Clear the DTCs. Repeat the IPC self-test.
    • Is DTC U0208:00 still present? 
    • Yes  : INSTALL a new DSM. REFER to MULTIFUNCTION ELECTRONIC MODULE Article. CLEAR the DTCs. REPEAT the IPC self-test. If DTC U0208:00 is still present, INSTALL a new IPC. REFER to INSTRUMENT PANEL CLUSTER (IPC)  . TEST the system for normal operation.
    • No  : The system is operating correctly at this time. The DTC may have been set due to high network traffic or an intermittent fault condition.
scientia non olet · About LEMON Manuals