Cowl Panel Grille
| Item | Part Number | Description |
|---|---|---|
| 1 | 17C526 | Wiper pivot arm nut cover |
| 2 | W709581 | Wiper pivot arm nut |
| 3 | 17527 LH/17526 RH | Wiper arm |
| 4 | - | Cowl panel grille side pin-type retainers |
| 5 | 5402228 | Cowl panel grille |
| 6 | W709919 | Cowl panel retainer clip (2 required) |
| 7 | 17K605-A | Windshield washer hose connector |
| 8 | N804837 | Cowl panel grille pin-type retainer |
- Remove the wiper pivot arms. For additional information, refer to WIPER SYSTEM & WASHER SYSTEM Article.
- Remove the cowl panel grille side pin-type retainers.
- Disconnect the windshield washer hose connector.
- Remove the 2 cowl panel grille retainer clips.
- Release the 2 cowl panel grille pin-type retainers.
- Disconnect the cowl panel grille from the retaining strip on the cowl.
- Spread the retaining tabs.
- Start from the driver side and work the cowl trim panel off, moving across the panel from the LH to the RH side to remove.
- Remove the cowl panel grille.
- To install, reverse the removal procedure.
NOTE:
Failure to follow the removal instruction may result in damaged retaining tabs and would require removal of the windshield glass.