Seat Cushion Cover - Front: Removal
NOTE:
If the passenger seat is equipped with an Occupant Classification System (OCS) bladder system, to prevent system failure, it is necessary to carry out the OCS system reset when a front passenger seat cushion is disassembled, a new cushion cover is installed or an OCS system service kit is installed. A scan tool is used to carry out the OCS system reset.
NOTE:
For component identification and locations, refer to SEAT - EXPLODED VIEW, FRONT in this service information.
- Remove the front seat backrest. For additional information, refer to SEAT BACKREST - FRONT in this service information.
- Disengage the cushion cover retainers from the cushion frame and seat track.
- Turn the cushion cover inside out, disengage the cushion cover wires from the retainers in the cushion foam pad and remove the cushion cover.
NOTE:
Use care when separating the cushion cover wires from the cushion foam pad clips or the clips can be torn from the cushion foam pad.