All vehicles

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

Release the tension on the rear parking brake. For additional information, refer to Parking Brake Cable Tension Release in this article.
Disconnect the RH cable from the LH conduit equalizer, then disconnect the LH cable from the front cable.

Fig 1: Locating RH Cable From LH Conduit Equalizer
Courtesy of FORD MOTOR CO.
Remove the 2 wire form bracket bolts from the frame rail and position the cable and conduit aside.
- To install, tighten to 40 Nm (30 lb-ft).

Release the parking brake cable from the LH bracket assembly.

Fig 1: Locating Parking Brake Cable At LH Bracket Assembly
Courtesy of FORD MOTOR CO.
Rotate the parking brake cable 90 degrees to release it from the parking brake actuating lever and remove the cable.

Fig 2: Locating Parking Brake Actuating Levers
Courtesy of FORD MOTOR CO.
To install, reverse the removal procedure.