Parking Brake Cable Tension Release
- With an assistant, release the parking brake cable tension by pulling down on the front cable at the cable-to-cable union until the parking brake control sector rotates to its stop and a 4 mm (0.15 in) x 150 mm (5.9 in) retainer pin can be inserted.
- With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING Article..
- Disconnect the cable at the cable-to-cable union by releasing the locking tab.
NOTE:
Make sure that the cable-to-cable union is connected to the front and rear cable before removing the brake control retaining pin and that the cable tension is reloaded slowly.