Pinpoint Test Am: The Turn Signal On Warning Chime Is Inoperative

AM1 CHECK THE KEY-IN-IGNITION WARNING CHIME OPERATION
- Ignition OFF.
- On vehicles without Intelligent Access (IA), insert the key into the ignition lock cylinder.
- On vehicles equipped with IA, place the ignition in the ACC mode.
- Open the LH front door and observe the key-in-ignition warning chime operation.
- Does the key-in-ignition warning chime operate correctly?
- Yes : GO to AM2.
- No : GO to PINPOINT TEST AJ (chime is always on) or GO to PINPOINT TEST AK (chime is inoperative).
AM2 CHECK THE TURN SIGNAL INDICATORS OPERATION
- Ignition ON.
- Verify the turn signal indicators operation.
- Do the turn signal indicators operate correctly?
- Yes : GO to AM3.
- No : GO to PINPOINT TEST S .
AM3 CHECK THE ODOMETER FOR CORRECT OPERATION
- Drive the vehicle and observe the odometer for correct operation.
- Does the odometer operate correctly?
- Yes : INSTALL a new SJB. REFER to MULTIFUNCTION ELECTRONIC MODULE Article. TEST the system for normal operation.
- No : GO to PINPOINT TEST H .