LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2011 >> Taurus Limited, AWD >> Repair and Diagnosis (Single Page) >> Body & Frame >> Door Locks >> Handles, Locks, Latches And Entry Systems >> Diagnosis And Testing >> Handles, Locks, Latches and Entry Systems - With Intelligent Access (IA) >> Pinpoint Tests >> Pinpoint Test AY: DTCs B106E, B106F >> PINPOINT TEST AY: DTCs B106E, B106F

PINPOINT TEST AY: DTCs B106E, B106F

NOTE: If DTC B106F is present and the Driver Door Module (DDM) is being replaced, the fault condition must be corrected first. Failure to correct the fault condition first may cause damage to the new DDM, resulting in a repeat repair.
  1. AY1 REVIEW THE DTCs 
    • Review the DTCs from the DDM self-test.
    • Is only DTC B106F present? 
    • Yes  : INSTALL a new DDM. REFER to DRIVER DOOR MODULE (DDM)  . TEST the system for normal operation.
    • No  : CORRECT any DTCs present other than DTC B106E (DTC B106F may also be present). REFER to DTC CHART  . After the repair, GO to AY2.
  2. AY2 CARRY OUT THE DDM SELF-TEST 
    • Carry out the DDM self-test.
    • Is only DTC B106F present? 
    • Yes  : INSTALL a new DDM. REFER to DRIVER DOOR MODULE (DDM)  . TEST the system for normal operation.
    • No  : The system is operating correctly at this time. The concern was caused by a fault in one of the output circuits, which is no longer present.
scientia non olet · About LEMON Manuals