Removal and Installation
NOTE:
For parts identification and location, refer to SEAT - EXPLODED VIEW, SECOND ROW in this service information.
- Remove the rear seat cushion. For additional information, refer to SEAT CUSHION - REAR in this service information.
- If equipped, route the heated seat jumper harness out of the cushion cover retainers on each side.
- From underneath the cushion assembly, remove the hog rings retaining the cushion trim cover wires and draw strings to the cushion foam pad wires.
- At installation, route the heated seat mat wire harness under the draw string.
- Separate the cushion cover wires from the foam pad clips and remove the cover.
- To install, reverse the removal procedure.
NOTE:
Use care when separating the cushion cover wires from the cushion foam pad clips, or the clips can be torn from the cushion foam pad.