Principles of Operation

NOTE: The Smart Junction Box (SJB) is also known as the Generic Electronic Module (GEM).

NOTE: When installing a new SJB, it must be configured for this feature, if originally equipped. When the Programmable Module Installation (PMI) procedure is carried out, the configuration is automatically loaded into the new module. Refer to MODULE CONFIGURATION SYSTEM article.

The DRL feature (when active) energizes the high beam shutters and provides voltage to the headlamp bulbs in series. This gives the appearance of the high beams illuminated at a reduced intensity.

The SJB controls the DRL by using various inputs to determine whether or not the DRL should be illuminated. These inputs include:

Ignition switch position
Headlamp switch position
Headlamps on or off
Transaxle gear selection

The DRL is not a programmable parameter for this vehicle.