LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2011 >> Fusion Hybrid >> Repair and Diagnosis >> External Pages >> Different car >> Section 1524 (Parking Brake System - Parking Brake & Actuation) >> Removal And Installation >> Parking Brake Cable - Rear >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2011 Lincoln MKT. However, it is still accessible from the selected car via links, so may be relevant.

Both cables 

  1. Release the parking brake cable tension. For additional information, refer to PARKING BRAKE CABLE TENSION RELEASE .

    RH cable 

  2. Separate the RH cable from the LH at the conduit equalizer and remove the cable from the wireform bracket.
  3. Remove the 3 parking brake cable bracket bolts.
    • To install, tighten to 15 Nm (133 lb-in).
  4. Remove the RH wheel well bracket bolt.
    • To install, tighten to 23 Nm (17 lb-ft).

    LH cable 

  5. Disconnect the conduit equalizer from the RH cable at the equalizer.
  6. Remove the wireform bracket bolt and separate the LH cable and bracket from the RH cable.
    • To install, tighten bolt to 12 Nm (106 lb-in).
  7. Remove the LH wheel well bracket bolt.
    • To install, tighten to 23 Nm (17 lb-ft).

    Both cables 

  8. Release the parking brake cable from the brake caliper and remove the cable.
  9. To install, reverse the removal procedure.
    • Inspect the parking brake system for correct operation.
scientia non olet · About LEMON Manuals