Removal and Installation
- Remove the floor console. For additional information, refer to
INSTRUMENT PANEL & CONSOLE -- FUSION, MILAN & MKZ
article.
- Make sure the parking brake control is in the released position.
- Disconnect the warning indicator switch electrical connector.
- Loosen the parking brake control adjusting nut.
- Remove the 2 parking brake control nuts.
- To install, tighten to 20 Nm (177 lb-in).
- Remove the parking brake control bolt and the parking brake control.
- To install, tighten to 20 Nm (177 lb-in).
- To install, reverse the removal procedure.