Scuff Plate Trim Panel - Front

Scuff Plate Trim Panel - Front

Removal and Installation

NOTE: On the MKZ, there is an outer lighted scuff plate. For additional information, refer to Scuff Plate Trim Panel - Front, Lighted Outer Scuff Plate Trim Panel - Front, Lighted Outer.

1. Pull the front inboard section of the scuff plate trim panel outward to release the 1 retaining clip.

2. NOTE: The 3 retaining clips must stay attached to the door weather strip and pinch weld.

Lift the scuff plate trim panel straight up to release the scuff plate trim panel from the 3 retaining clips.

3. To install, reverse the removal procedure.
- Align the scuff plate trim panel into the clips and snap into place.