DTC P0453: Evaporative Emission System Pressure Sensor/Switch High
P0453 - EVAPORATIVE EMISSION SYSTEM PRESSURE SENSOR/SWITCH HIGH
| For Vehicles With NVLD Module | |||
| Description: | The natural vacuum leak detection (NVLD) module monitors the position of the NVLD module pressure switch. This DTC sets if the NVLD module pressure switch voltage is out of range high. | ||
| Possible Causes: |
|
||
| Diagnostic Aids: | |||
| For All Others | |||
| Description: | The powertrain control module (PCM) monitors the evaporative emission (EVAP) control system fuel tank pressure (FTP) sensor input signal to the PCM. The test fails when the signal average jumps above a minimum allowable calibrated parameter. | ||
| Possible Causes: |
|
||
| Diagnostic Aids: | An FTP voltage PID reading greater than 4.85 volts with the ignition ON, engine OFF or with the ignition ON, engine running, indicates a concern is present. | ||
| Application | Key On Engine Off | Key On Engine Running | Continuous Memory |
| Fiesta | GO to PINPOINT TEST HZ . | ||
| All others | GO to PINPOINT TEST HX . | ||