DTC P0335: Crankshaft Position Sensor A Circuit
P0335 - CRANKSHAFT POSITION SENSOR A CIRCUIT
| Description: | The powertrain control module (PCM) continuously monitors this sensor for concerns. This DTC sets when the PCM detects that the crankshaft position (CKP) sensor signal is missing for greater than a calibrated number of camshaft revolutions. | ||
| Possible Causes: |
|
||
| Diagnostic Aids: | An inactive CKP signal causes a no start condition. Monitor the RPM PID while cranking the engine. A value of 0 RPM indicates a CKP concern. | ||
| Application | Key On Engine Off | Key On Engine Running | Continuous Memory |
| All | GO to PINPOINT TEST JD . | ||