LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2011 >> Focus S, Standard >> Repair and Diagnosis >> Engine Performance >> Testing & Diagnosis >> Engine Controls - Powertrain DTC Charts & Descriptions - DTC P0001 Through DTC P0217 - (Except Diesel & Hybrid) >> DTC P0217: Engine Coolant Over Temperature Condition

DTC P0217: Engine Coolant Over Temperature Condition

P0217 - ENGINE COOLANT OVER TEMPERATURE CONDITION

For Vehicles With 3.5L GTDI Engine 
Description:  Indicates an engine overheat condition was detected by the engine temperature sensor (CHT or ECT depending how the vehicle is equipped).
Possible Causes: 
  • Engine cooling system concerns
  • Low engine coolant level
  • Base engine concerns
  • Excessive engine RPM in NEUTRAL or operated in the incorrect transmission gear
  • High engine RPM with engine temperature within a calibrated limit of an overheating condition
Diagnostic Aids:  This DTC may be accompanied by other DTCs. If DTC P1285 or P1299 is present, disregard DTC P0217 at this time. Diagnose DTC P1285 or P1299 first.
Monitor the engine temperature PID (CHT or ECT) for an overheat condition. Typical engine temperature should be close to cooling system thermostat specification.
If excessive engine RPM is suspected, refer to POWERTRAIN CONTROL SOFTWARE , ENGINE FLUID TEMPERATURE MANAGEMENT , for additional information.
For All Others 
Description:  Indicates an engine overheat condition was detected by the engine temperature sensor (CHT or ECT depending how the vehicle is equipped).
Possible Causes: 
  • Engine cooling system concerns
  • Low engine coolant level
  • Base engine concerns
Diagnostic Aids:  This DTC may be accompanied by other DTCs. If DTC P1285 or P1299 is present, disregard DTC P0217 at this time. Diagnose DTC P1285 or P1299 first.
Monitor the engine temperature PID (CHT or ECT) for an overheat condition. Typical engine temperature should be close to cooling system thermostat specification.
Application  Key On Engine Off  Key On Engine Running  Continuous Memory 
All GO to PINPOINT TEST DX .