LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2011 >> Focus S, Standard >> Repair and Diagnosis >> Engine Performance >> Testing & Diagnosis >> Engine Controls - Powertrain DTC Charts & Descriptions - DTC P0001 Through DTC P0217 - (Except Diesel & Hybrid) >> DTC P0130: O2 Circuit (Bank 1, Sensor 1)

DTC P0130: O2 Circuit (Bank 1, Sensor 1)

P0130 - O2 CIRCUIT (BANK 1, SENSOR 1)

For Vehicles With Universal HO2S 
Description:  The powertrain control module (PCM) monitors the heated oxygen sensor (HO2S) for a circuit concern. This DTC sets when the PCM detects a concern with one of the circuits used to determine the oxygen content in the exhaust gas.
Possible Causes: 
  • Open UO2S circuit
  • Open UO2SGREF circuit
  • UO2S circuit short to voltage or ground
  • UO2SGREF circuit short to voltage or ground
  • UO2SPC circuit short to voltage or ground
  • UO2SPCT circuit short to voltage or ground
  • Damaged universal HO2S
Diagnostic Aids: 
For Vehicles With HO2S (4-pin) 
Description:  The powertrain control module (PCM) monitors the heated oxygen sensor (HO2S) for a circuit concern. This DTC sets when the PCM detects a concern with one of the circuits used to determine the oxygen content in the exhaust gas.
Possible Causes: 
  • HO2S circuit open
  • SIGRTN circuit open
  • Incorrect connections
  • Damaged or corroded terminals
  • Exhaust temperature significantly higher than expected
  • Damaged HO2S
Diagnostic Aids:  Inspect the connectors for signs of damage, water ingress, or corrosion.
Application  Key On Engine Off  Key On Engine Running  Continuous Memory 
Edge,
Escape/Mariner 2.5L
Automatic
Transmission,
Escape/Mariner
3.0L,
E-Series 4.6L,
E-Series 5.4L,
Expedition,
Explorer,
F-150,
Flex,
F-Series Super Duty,
Fusion 2.5L,
Fusion 3.0L,
Milan,
MKS,
MKT,
MKX,
Mustang,
Navigator,
Taurus
GO to PINPOINT TEST DZ .
All others GO to PINPOINT TEST DW .