LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2011 >> Focus S, Standard >> Repair and Diagnosis (Single Page) >> Electrical >> Gauges >> Information Center - Instrumentation, Message Center And Warning Chimes >> Removal And Installation >> Instrument Cluster (IC) >> Installation

Instrument Cluster (IC): Installation

  1. Position the IC in the instrument panel.
    • Connect the electrical connector.
  2. Install the 4 IC screws.
  3. Install the IC finish panel and the 2 screws.
  4. If installing a new IC, download the IC configuration information from the scan tool into the new IC. For additional information, refer to PMI in MODULE CONFIGURATION SYSTEM article.
    5. NOTE: If a new IC is installed, the IC and the PCM require a parameter reset to allow the IC and the PCM to recognize each other. Failure to carry out the parameter reset to the IC and the PCM may result in a no start condition.
  5. If installing a new IC, carry out the parameter reset procedure. For additional information, refer to ANTI-THEFT SYSTEM - PASSIVE ANTI-THEFT SYSTEM (PATS) article.
  6. If installing a new IC, carry out the key programming procedure. For additional information, refer to ANTI-THEFT SYSTEM - PASSIVE ANTI-THEFT SYSTEM (PATS) article.
scientia non olet · About LEMON Manuals